Step 1: Preparation

Please clean the phone with included alcohol wipe and cloth. Make sure there is no debris, dust and fingerprints on the phone. Select a clean, flat surface with ample lighting to make alignment easier. 

Step 2: Application

Install Note 10 skin is very simple and straightforward. Align the skin with camera, led cutouts alone with the top edge. Make sure the top edge is perfectly aligned. Once skin is aligned, apply the center section first, and make sure there is no air bubble under the skin.

Step 3: Reapplying

During the installation, you might need to reapply the skin when not aligned straight. Carefully remove the skin with gentle force from device, pulling the skin too hard or too fast off the phone might overstretched or even ripped the vinyl.

Step 4: Cure and Enjoy

Once the center section has been applied, please grab the hair dryer and heat up side edge for couple of seconds until the skin become soft. Firmly apply the skin outward once the vinyl is soften from the heating. Repeat this step until both side is firmly applied. 

Congrats on your new SopiGuard Vinyl Skin! Again, please reach out if you have any questions, problems or concerns, and thank you for being a valuable customer.